| |
Lights
5- 45-feet of EL Neon wire. The Fish Driver is a blinking unit,
until you cut the white wire, making it constant.
Fish Driver + 1 (#DF1)
Special priced
$8.95
|
|
| |
| |
|
|
| |
FISH
DRIVER + 2 connector sets (#DF2)
Lights
5- 45 feet of EL wire. The Fish Driver is a blinking unit, until
you cut the white wire, making it constant. This unit has 2 Plug
& Play connector sets.
Fish
Driver- 2 connector sets (#DF2)
Special priced
$9.95
|
|
|
|
| |
PIPSQUEAK DRIVER (#DPS)
Our
Pipsqueak Driver will light 4- 20 feet of EL wire. The input is
a 9 Volt battery cap, which can be supplied with 9- 13.8 Volts DC.
Or, use our Long 8 AA Battery Pack (#ACL8AA) to run your Pipsqueak
Driver off of 8 AA batteries (12 Volts) instead of a 9 Volt battery,
which will make your EL wire glow brighter, & for longer!
The
Pipsqueaks are our smallest medium length driver, lightweight &
perfect for many projects. They are perfect for Plug & Play use
in PC Cases with our Case Mod Power Harness. Please note the new,
larger design with 2 screw hole mounting brackets! (Dimensions:
1 1/8 " x 1 1/8 " x 1")It comes with 1 Plug & Play connector set
Pipsqueak
Driver (#DPS)
Special priced
$9.95
|
|
|
|
| |
LARGE
STROBING DRIVER (#DLSD)
Our
Large Strobing Driver will strobe 10-50 feet of EL wire. It is powered
using 12 to 14 Volts DC and comes with one Plug & Play connector
set and a 9 Volt battery cap.
Large
Strobing Driver (#DLSD)
Special priced
$18.95
|
|
|
|
| |
Big
Boy Driver Substitute (#DBB)
Brand
new Big Boy! Can power 20- 100 feet of EL wire. 12- 14 Volt input
power requirement.
Please
note: this driver will cause your EL wire to "flicker" if overloaded.
Some people particularly like this effect.
Big
Boy Driver Substitute (#DBB)
Special priced
$19.95
|
|
|
|
| |
Cat-09
Two - Ten Channel Sequencer (#SQ09)
The
Cat-09 is HERE!
Cat-09
Two - Ten Channel Sequencer (#SQ09)
Special priced
$76.95
|
|
|
|
| |
8AA
Battery Cage (#AC8AAL)
Use
this 8AA Battery Cage instead of a 9 Volt Battery when powering
your Fish Driver, Pipsqueak Driver, Classic Pipsqueak Driver, Large
Strobing Driver, Low Frequency Driver, 4 Channel Variable Speed
Sequencer, Cat09 10 Channel Sequencer, Big Boy Substitute Driver,
or Sound Activated Driver.
8
AA batteries = 12 Volts Increasing the voltage applied to your EL
wire will increase the brightness! 8 AA batteries will last MUCH
longer than a single 9 Volt battery, so you can stay glowing bright
all night long!
8AA Battery Cage (#AC8AAL)
Special priced
$6.95
|
|
|
|
| |
TRI-MODE
DRIVER
Plug
and Play with dual connecters for added versatility. Modes - slow
blink, fast blink, and continuous
Runs
15 feet of wire at maximum brightness. (Can run 20 feet) Driver
takes 2 AA batteries. Call for quantity
discount!
Tri-Mode Driver
Special priced
$12.95
|
|
|
|
| |
VARIABLE
SPEED 9V DRIVER
Runs
up to 30 feet on a 9-volt battery. Will last up to 24 hours in Blink
mode, less on constant mode.
Variable
speed dial goes through constant, blink and strobe modes with a
seperate variable brightness dial - will support 1 connecter. Call
for quantity discount!
Variable Speed 9V Driver
Special priced
$14.95
|
|
|
|
| |
LyTec™
INVERTER DRIVER
The
LyTec™
Inverter is a small portable battery pack inverter designed to drive
up to 4m (13.1ft) of LyTec™ Wire..
•
Three operating modes: Continuous, Flashing and strobing
•
Portable
•
Battery operated by two AA 1.5VDC
•
LED Power On Indicator
•
Low power consumption
•
Low audible noise
•
Indoor use
Call for quantity discount!
LyTec™
Inverter
Special priced
$12.95
|
|
|
|
|
Back
to
SHOPPING
|
Back
to SHOPPING
